Electrostatic Interactions to Attach Latex to Pigment Surface to Reduce Binder Migration

Authors

  • Pradnya D. Rao Paper Surface Science Program, Department of Chemical and Biomedical Engineering, University of Maine, Orono, ME 04469, USA and Department of Chemistry, Frontier Institute of Research in Sensor Technologies (FIRST), University of Maine Orono, ME 04469, USA
  • Douglas W. Bousfield Paper Surface Science Program, Department of Chemical and Biomedical Engineering, University of Maine, Orono, ME 04469, USA
  • Carl P. Tripp Paper Surface Science Program, Department of Chemical and Biomedical Engineering, University of Maine, Orono, ME 04469, USA and Department of Chemistry, Frontier Institute of Research in Sensor Technologies (FIRST), University of Maine Orono, ME 04469, USA

DOI:

https://doi.org/10.6000/2369-3355.2022.09.01

Keywords:

Binder migration, cationic pigment, porosity, opacity, binder attachment, paper coating

Abstract

For many paints, paper coatings, and other pigmented coatings, latex and soluble binders are used to impart mechanical properties. However, non-uniform latex binder distributions are often observed in the thickness direction during application and drying, leading to quality issues. While several publications have documented this issue, few solutions are offered in the literature. Here we report a simple process to use electrostatic interactions to attach latex binder to pigments. Coating suspensions are generated using cationic precipitated calcium carbonate (PCC) pigments that are mixed with anionic styrene-butadiene (SB) latex binders resulting in latex-covered pigments. The migration of latex binder in coatings generated on various substrates under various drying conditions was measured using Raman spectroscopy and compared with reference coatings. The new system shows reduced latex binder migration for most situations than those obtained with the reference coating. The coated papers were also measured for strength, opacity, gloss, water drainage rate, and porosity. Little difference is seen in the picking strength of the coating and gloss compared to coatings prepared with standard formulations. Water drainage rate, opacity, and porosity were higher for latex-covered pigment (LCP) coatings than the reference standard coating; this increased porosity is likely due to the strong electrostatic attraction that exists between the cationic pigment and anionic latex binder that reduces the densification of the coating during drying.

References

Hitomi S, Kubota K, Horiba T, Hida K, Matsuyama T, Oji H, Yasuno S, Komaba S. Application of acrylic-rubber-based latex binder to high-voltage spinel electrodes of lithium-ion batteries. ChemElectroChem 2019; 6: 5070-5079. https://doi.org/10.1002/celc.201901227

Isozumi H, Horiba T, Kubota K, Hida K, Matsuyama T, Yasuno S, Komaba S. Application of modified styrene-butadiene-rubber-based latex binder to high-voltage operating LiCoO2 composite electrodes for lithium-ion batteries. J Power Sources 2020; 468: 228332. https://doi.org/10.1016/j.jpowsour.2020.228332

Danková M, Kalendová A, Machotová J. Waterborne coatings based on acrylic latex containing nanostructured ZnO as an active additive. J Coatings Technol Res 2020; 17: 517-529. https://doi.org/10.1007/s11998-019-00302-6

Worlee A, Homdong N, Hayeemasae N. Application of polymer blend based on natural rubber latex and acrylic resin as a binder for wall paints. IOP Conference Series: Materials Science and Engineering 2020; 773: 12-32.

Kwon S, Oh K, Shin SJ, Lee H.L. Effects of hydroxyethyl methacrylate comonomer in styrene/acrylate latex on coating structure and printability. Prog Org Coatings 2020; 147. https://doi.org/10.1016/j.porgcoat.2020.105862

Kwon S, Oh K, Shin SJ, Lee HL. Structural changes of the coating layer by styrene/acrylate latex with hydroxyethyl methacrylate. ACS Omega 2019; 4: 18405-18412. https://doi.org/10.1021/acsomega.9b02671

Al-Turaif HA, Bousfield DW. The influence of pigment size distribution and morphology on coating binder migration. Nord Pulp Pap Res J 2005; 20: 335-339. https://doi.org/10.3183/npprj-2005-20-03-p335-339

Lepoutre P. The Structure of paper coatings: An update. Prog Org Coatings 1989; 17: 89-106. https://doi.org/10.1016/0033-0655(89)80016-0

Lee HL, Youn HJ, He M, Chen J. Back-trap mottle: A review of mechanisms and possible solutions. BioResources 2021; 16: 6426-6447. https://doi.org/10.15376/BIORES.16.3.LEE

Hagen KG. Fundamental assessment of the effect of drying on coating quality. TAPPI Coat Conf 1985; 69: 131-137.

Du Y, Liu J, Wang J, Wang B, Li H, Su Y. Starch-based bio-latex redistribution during paper coating consolidation. Prog Org Coatings 2017; 106: 155-162. https://doi.org/10.1016/j.porgcoat.2017.02.016

Nechita P. The influence of drying conditions of clay-based polymer coatings on coated paper properties. Coatings 2021; 11: 1-13. https://doi.org/10.3390/coatings11010012

Kline JE. Fundamental aspects of latex mobility in paper coatings. Tappi Advanced Coating Fundamentals Symposium Proceedings; 1993; 93-100.

Groves R, Matthews GP, Heap J, McInnes MD, Penson JE, Ridgway CJ, C.F.Baker. Binder migration in paper coatings - a new perspective. 12th Fundamental Research Symposium 2001; 1149-1182.

Fujiwara H, Kline JE. Ultraviolet absorption of styrene-butadiene latex on pigment-coated paper. Tappi journal 1987; 70: 97-100.

Kenttä E, Pöhler T, Juvonen K. Latex uniformity in the coating layer of paper. Nord Pulp Pap Res J 2006; 21: 665-669. https://doi.org/10.3183/npprj-2006-21-05-p665-669

Chattopadhyay R. Dynamics of particle movements in paper coatings. Ph.D. thesis. University of Maine 2014.

Halttunen M, Löija M, Vuorinen T, Stenius P, Tenhunen J, Kenttä E. Determination of SB-latex distribution at paper coating surfaces with FTIR/ATR spectroscopy. Tappi Coating and Graphic Arts Conference and Trade Fair; 2003; 203-211.

He P, Bitla S, Bousfield D, Tripp CP. Raman spectroscopic analysis of paper coatings. Appl Spectrosc 2002; 56: 1115-1121. https://doi.org/10.1366/000370202760295322

Bitla S, Tripp CP, Bousfield DW. A Raman spectroscopic study of migration in paper coatings. J Pulp Pap Sci 2003; 29: 382-385.

Kugge C, Craig VSJ, Daicic J. A scanning electron microscope study of the surface structure of mineral pigments, latices, and thickeners used for paper coating on non-absorbent substrates. Colloids Surfaces A Physicochem Eng Asp 2004; 238: 1-11. https://doi.org/10.1016/j.colsurfa.2004.02.029

Pöhler T, Juvonen K, Sneck A. Coating layer microstructure and location of binder - results from SEM analysis.TAPPI Advanced Coating Fundamentals Symposium 2006; 79-89.

Lee JH, Lee HL. Characterization of the paper coating structure using focused ion beam and field-emission scanning electron microscopy. 2. structural variation depending on the glass transition temperature of an S/B latex. Ind Eng Chem Res 2018; 57: 16718-16726. https://doi.org/10.1021/acs.iecr.8b04802

Dahlström C, Allem R, Uesaka T. New method for characterizing paper coating structures using argon ion beam milling and field emission scanning electron microscopy. J Microsc 2011; 241: 179-187. https://doi.org/10.1111/j.1365-2818.2010.03418.x

Dahlström C, Uesaka T. Microstructure variations in paper coating: direct observations. Ind Eng Chem Res 2012; 51: 8246-8252. https://doi.org/10.1021/ie202874z

Di Risio S, Yan N. Characterizing coating layer z-directional binder distribution in paper using atomic force microscopy. Colloids Surfaces A Physicochem Eng Asp 2006; 289: 65-74. https://doi.org/10.1016/j.colsurfa.2006.04.007

Patel AA, Feng J, Winnik MA, Vancso GJ, Dittman McBain CB. Characterization of latex blend films by atomic force microscopy. Polymer 1996; 37: 5577-5582. https://doi.org/10.1016/S0032-3861(96)00677-5

Rajala P, Häkkänen H, Berg CG, Solin R. The effect of intense air drying on material distribution and quality in coated papers. Dry Technol 2003; 21: 1941-1956. https://doi.org/10.1081/DRT-120026426

Hagen KG. Using infrared radiation to dry coatings. Tappi J 1989; 72: 77-83.

Zang YH, Du J, Du Y, Wu Z, Cheng S, Liu Y. The migration of styrene-butadiene latex during the drying of coating suspensions: When and how does migration of colloidal particles occur? Langmuir 2010; 26: 18331-18339. https://doi.org/10.1021/la103675f

Du Y, Zang YH, Du J. Effects of starch on latex migration and on paper coating properties. Ind Eng Chem Res 2011; 50: 9781-9786. https://doi.org/10.1021/ie200807w

Ranger AE. Binder migration during drying of pigment coatings. Pap Technol 1994; 35: 40-46.

Jabbal M, Zhong S. The near wall effect of synthetic jets in a boundary layer. Int J Heat Fluid Flow 2008; 29: 119-130. https://doi.org/10.1016/j.ijheatfluidflow.2007.07.011

Lyons A, Iyer R, Bousfield DW. Particle motion modeling for particle size distributions in blade geometries. TAPPI Advanced Coating Fundamentals Symposium 2003; 95-105.

Pan SX, Davis HT, Scriven LE. Modeling moisture distribution and binder migration in drying paper coatings. Tappi J 1995; 78: 127-143.

Ferstl E, Gabriel M, Gomernik F, Müller SM, Selinger J, Thaler F, Bauer W, Uhlig F, Spirk S, Chemelli A. Investigation of the adsorption behavior of jet-cooked cationic starches on pulp fibers. Polym 2020; 12: 2249. https://doi.org/10.3390/POLYM12102249

Wei Q, Zheng H, Zhu M, Han X, Li Y. Starch-based surface-sizing agents in paper industry : An overview. Pap Biomater 2021; 6: 54-61. https://doi.org/10.1213/j.issn.2096-2355.2021.04.007

Sharma M, Aguado R, Murtinho D, Valente AJM, Mendes De Sousa AP, Ferreira PJT. A review on cationic starch and nanocellulose as paper coating components. Int J Biol Macromol 2020; 162: 578-598. https://doi.org/10.1016/J.IJBIOMAC.2020.06.131

Ghasemian A, Ghaffari M, Ashori A. Strength-enhancing effect of cationic starch on mixed recycled and virgin pulps. Carbohydr Polym 2012; 87: 1269-1274. https://doi.org/10.1016/j.carbpol.2011.09.010

Springer AM, Chandrasekaran S, Wegner TH. Influence of starch on drainage and retention in paperboard mill systems. Tappi J 1984; 67: 104-108.

Chi K, Wang H, Catchmark JM. Sustainable starch-based barrier coatings for packaging applications. Food Hydrocoll 2020; 103: 105696. https://doi.org/10.1016/j.foodhyd.2020.105696

Scriven LE, Nowicki SC. On the physics of drying and binder migration in coated papers.TAPPI Coating Conference 1990; 49-63.

Al-Turaif H, Bousfield DW, LePoutre P. The influence of substrate absorbency on coating surface chemistry. Prog Org Coatings 2002; 44: 307-315. https://doi.org/10.1016/S0300-9440(02)00071-1

Zhen ZH, Wang ZS. Influence of coating binder migration on coated paper optical properties. Adv Mater Res 2013; 746: 114-117. https://doi.org/10.4028/www.scientific.net/AMR.746.114

Zhen ZH, Wang ZS. Study of coating binder migration and affected parameters. adv mater res 2013; 790: 45-48. https://doi.org/10.4028/www.scientific.net/AMR.790.45

Downloads

Published

2022-05-11

How to Cite

Rao, P. D., Bousfield, D. W., & Tripp, C. P. (2022). Electrostatic Interactions to Attach Latex to Pigment Surface to Reduce Binder Migration. Journal of Coating Science and Technology, 9, 1–10. https://doi.org/10.6000/2369-3355.2022.09.01

Issue

Section

Articles