Numerical Prediction of Thermal Storage Using Phase Change Material

Authors

  • S. Sami Catholic University of Cuenca
  • F. Tardy Catholic University of Cuenca

DOI:

https://doi.org/10.6000/1929-6002.2015.04.03.1

Keywords:

Phase change material, thermal storage, numerical model, simulation

Abstract

A numerical mathematical model has been developed to predict the thermal behavior of phase change material during thermal storage. The model includes the effects of various mechanisms of heat transfer such as conduction, convection as well as fusion of the phase change material. Water/Ice was used as a phase change material. The thermal behavior of the phase change material during cooling has been studied experimentally and analyzed under different conditions. Comparisons were made against experimental data for validation of the predictive model. The model fairly predicted experimental data obtained at various inlet conditions.

Author Biographies

S. Sami, Catholic University of Cuenca

Center for Renewable Energy

F. Tardy, Catholic University of Cuenca

Center for Renewable Energy

References

Farid MM, Khudhair AM, Razack SA, Al-Hallaj S. A review on phase change energy storage material. Energy Conversion and Management 2004; 45: 1597. http://dx.doi.org/10.1016/j.enconman.2003.09.015

Sauciuc I, Akbarzadeh A, Johnson P. Characteristics of two-phase closed hermosyphons for medium temperature heat recovery applications. Heat Recovery Systems and CHP 1995; 15(7): 631-640. http://dx.doi.org/10.1016/0890-4332(95)90043-8

Bellecci C, Conti M. Transient behaviour analysis of a latent heat thermal storage module. International Journal of Heat Mass Transfer 1993; (36): 3851-3857. http://dx.doi.org/10.1016/0017-9310(93)90065-E

Elawadhi EM. Phase change process with free convection in a circular enclosure; numerical simulation. Computer & Fluids 2005; (33): 1335-148.

Tardy F, Sami SM. An experimental study determining behaviour of heat pipes in thermal storage. International Journal of Ambient Energy 2008; 29(3). http://dx.doi.org/10.1080/01430750.2008.9675072

Razali T, Hamdani, Irwasnsyah, Zaini. Investigation of performance of solar water heater system using paraffin wax. ARPN Journal of Engineering and Applied Sciences 2014; 9(10).

Thirugnanm C, Marimuthu P. Experimental analysis of latent heat thermal energy storage using paraffin wax as phase change material. International Journal of Engineering and Innovative Technology (IJEIT) 2013; 3(2).

Incropera PF, DeWitt DP. Fundamentals of heat and mass transfer, Fourth edition, John Wiley & Sons, Inc. New York 1999.

Kreith F. Mechanical engineering handbook, Heat and mass transfer, CRC Press LLC 1999.

McQuiston FC, Tree DR. Optimum Space Envelopes of the Finned Tube Heat Transfer Surface. Trans ASHRAE 1972; 78: 144-148.

Peterson GP. An Introduction to Heat Pipe, Wiley, New York 1994.

Holman JP. Heat Transfer, Ninth Edition, McGraw-Hill, New York 2002.

Yang F, Yuan X, Lin G. Waste heat recovery using heat pipe heat exchanger for heating automobile using exhaust gas. Applied Thermal Engineering 2003; 23: 367-372. http://dx.doi.org/10.1016/S1359-4311(02)00190-4

Abd El-Baky MA, Mohamed MM. Heat pipe heat exchanger for heat recovery in air conditioning. Applied Thermal Engineering 2007; 27: 795-801. http://dx.doi.org/10.1016/j.applthermaleng.2006.10.020

Liu G, et al. The application of heat pipe heat exchanger in exhaust gas heat recovery and its thermodynamic analysis, 5th International heat pipe symposium, Melbourne, Australia 1996.

Downloads

Published

2015-09-23

How to Cite

Sami, S., & Tardy, F. (2015). Numerical Prediction of Thermal Storage Using Phase Change Material. Journal of Technology Innovations in Renewable Energy, 4(3), 80–90. https://doi.org/10.6000/1929-6002.2015.04.03.1

Issue

Section

Articles